Forum Home » Enterprise Products » Fuse HQ

Thread: How can we setup FUSE HQ with high availability (FT mode or HA mode) ?

 
This question is not answered. Helpful answers available: 2. Correct answers available: 1.


Permlink Replies: 2 - Last Post: Oct 12, 2009 4:34 PM Last Post By: hzbarcea
indika

Posts: 15
Registered: 08/16/09
How can we setup FUSE HQ with high availability (FT mode or HA mode) ?
Posted: Oct 12, 2009 6:52 AM
 
  Click to reply to this thread Reply
Hi All,

How can we setup FUSE HQ with high availability (FT mode or HA mode)?

Is there any document explaining the solution architecture for various different combination of implementation?

Thank you in advance.

cheers,
Indika Peiris
hzbarcea

Posts: 25
Registered: 09/25/07
Re: How can we setup FUSE HQ with high availability (FT mode or HA mode) ?
Posted: Oct 12, 2009 3:38 PM   in response to: indika in response to: indika
 
  Click to reply to this thread Reply
Fuse HQ is based on Hyperic HQ. You can check out the Failover Guide for HQ at:
http://support.hyperic.com/display/DOCSHQ32/HQ+High+Availability+Failover+Guide
hzbarcea

Posts: 25
Registered: 09/25/07
Re: How can we setup FUSE HQ with high availability (FT mode or HA mode) ?
Posted: Oct 12, 2009 4:34 PM   in response to: indika in response to: indika
 
  Click to reply to this thread Reply
Fuse HQ is based on Hyperic HQ. You can check out the Failover Guide for HQ at:
http://support.hyperic.com/display/DOCSHQ32/HQ+High+Availability+Failover+Guide